UART » History » Version 22
Denis 'GNUtoo' Carikli, 12/17/2018 02:05 PM
| 1 | 1 | Denis 'GNUtoo' Carikli | h1. Serial port |
|---|---|---|---|
| 2 | |||
| 3 | 12 | Denis 'GNUtoo' Carikli | There is an in-depth article covering several Samsung devices in the [[SamsungSerial]] page |
| 4 | 11 | Denis 'GNUtoo' Carikli | |
| 5 | 1 | Denis 'GNUtoo' Carikli | h2. Settings |
| 6 | 12 | Denis 'GNUtoo' Carikli | |
| 7 | 14 | Denis 'GNUtoo' Carikli | |_. Device |_. I/O voltage |_. ID<->GND |_. SOC TX |_. SOC RX |_. switch |_. Comments | |
| 8 | 22 | Denis 'GNUtoo' Carikli | | I9300 | 1.8V[1] | 619 kOhms[3] | D- | D+ | | It gives a shell once Replicant has booted | |
| 9 | | [[NexusSI902xSerial|Nexus S]] | 619K | [[NexusSI902xSerial#Hardware-setup|150 kOhm]] | | | FSA9480 | | |
||
| 10 | | [[GalaxyNexusI9250SerialConsole|Galaxy Nexus]] | 619 kOhms[4] | | | | | | |
||
| 11 | 20 | Denis 'GNUtoo' Carikli | | [[OptimusBlackSerial|Optimus Black]] | | N/A[2] | | | DP3T | | |
| 12 | 17 | Denis 'GNUtoo' Carikli | |
| 13 | 21 | Denis 'GNUtoo' Carikli | h2. Other links |
| 14 | |||
| 15 | 22 | Denis 'GNUtoo' Carikli | * |
| 16 | 1 | Denis 'GNUtoo' Carikli | |
| 17 | fn1. Measured between USB GND and USB VCC |
||
| 18 | |||
| 19 | fn2. Code is required to use the switch as you need to configure both the MUIC and DP3T switch |
||
| 20 | 22 | Denis 'GNUtoo' Carikli | |
| 21 | fn3. See "The related driver source code":https://git.replicant.us/replicant/kernel_samsung_smdk4412/tree/drivers/misc/max77693-muic.c#n102 |
||
| 22 | |||
| 23 | fn4. See the "postmarketOS wiki page on Serial debugging":https://wiki.postmarketos.org/wiki/Serial_debugging |