UART » History » Revision 53
« Previous |
Revision 53/93
(diff)
| Next »
Denis 'GNUtoo' Carikli, 03/08/2020 01:57 AM
UART¶
There is an in-depth article covering several Samsung devices in the SamsungSerial page
Settings¶
Device and documentation | I/O voltage | ID<->GND | SOC TX | SOC RX | switch | stock bootloader settings | Comments |
---|---|---|---|---|---|---|---|
GT-I9100 | MAX8997 | ||||||
GT-I9100G_CHN_CHN | 1.8V8 ? | 619k9 | D- | D+ | ? | 115200 8N1 | Very few prints from Xloader, the next bootloader used by Android 2.6.3 doesn't seem to print much |
GT-I9300 | 1.8V1 | 619 kOhms3 | D- | D+ | MAX776935 | * speed: 115200 * pressing the volume-down button during boot increase verbosity |
It gives a shell once Replicant 6 has booted |
GT-I9305 | |||||||
GT-N7100 | ? | ||||||
GT-N7105 | ? | ||||||
Galaxy Nexus (GT-I9250) | 619 kOhms4 | D+ | D- | FSA94807 | * By default: ttyFIQ0, 115200 8N1 * With patching: ttyO2, 115200 8N1 See GalaxyNexusI9250SerialConsole for more details. |
||
Nexus S | 150 kOhm | FSA9480 | |||||
Optimus Black (P970) | 1.8V6 | N/A2 | DP3T | ||||
ODROID-U3, console UART | 1.8V | connector | ttySAC1, 115200 8N1 | ||||
ODROID-U3, IO pins UART | 1.8V | connector | ttySAC0, 115200 8N1 |
1 Measured between USB GND and USB VCC
2 Code is required to use the switch as you need to configure both the MUIC and DP3T switch
3 See The related driver source code
4 See the postmarketOS wiki page on Serial debugging
5 See the driver and the ifixit teardown
6 Reference: OptimusBlackSerial
7 See board-tuna-connector.c fsa9480.c in kernel_samsung_tuna
8 Works, as it was tested on the device. TODO: measure the voltage, as lower UART voltages often works with higher voltage levels.
9 Works, as it was tested on the device. TODO: look the official reference in the driver for it.
Datasheets¶
Interesting links¶
- There is a page on Serial debugging on the postmarketOS wiki that contains information for using the serial port for many smartphones models.
- mv-uart A serial port adapter with configurable voltages (and GPIOs)
- DHylands_SGS2_SerialAdapter : A very compact setup but with fixed resistor value.
Updated by Denis 'GNUtoo' Carikli over 4 years ago · 53 revisions